bluedragon
Jul 11 2008, 06:44 PM
Hi, I recently switched to a new motherboard ASUS P5Q. At first I liked the motherboard because of the features it has to offer but now its a complete turn-off First thing that I noticed was Realtek ALC1200 (thats the sound card) on this board is not allowing Jack retasking on the back panel. I don't have any front connections since my cabinet doesn't have these. Is this a problem or is it normal? I had Realtek audio in my other board (XFX 650i Ultra  ) but this is the first time i've noticed this. Please suggest, what should I do. I seriously need that component, since My 5.1 connectors are quite FAT so I cannot plug it into the 2,3,5 configuration ------------------- (1)o (2)o (3)o (4)o (5)o (6)o ------------------- 2 is Rear 3 is Center/Sub 5 is Front My problem is that my connectors are quite fact I am attaching a screenshot anyways.. So , I hope u can imagine what will happen when i put the three connectors simultaneously .. Realtek doesn't even have this device listed on their site. So no Company drivers for this. I am stuck with this stupid drivers from Asus. I had an XFX 650i Ultra motherboard and it allowed me to put any jack in any of the pins and configure that as desired .. So i used to go with 1,5,3. It was just fine untill my motherboard died.. I hope theres a solution for this.. thanks
Reply
Live-Dimension
Jul 14 2008, 07:47 AM
You can get cables which do exactly the same as the picture shown - one side is a 3.5mm jack, the other are RCA plugs. It shouldn't be too expensive, but cables might be a little short. The 3.5mm side is actually quite thick - I can only just get three next to each other on the back of a sound-blaster audigy 2 zs card. The cables might not fit in the back either.
Reply
ronnygeo
Jul 20 2008, 12:08 PM
Try another RCA-3.5 Philip jack adaptor or get the cable told above.. ie one side is RCA female and the other side with 3.5 philips jack..
Reply
Galahad
Jul 21 2008, 01:52 AM
I agree with afore mentioned cable usage... I have SBLive 5.1, and I use RCA-to-Jack cable... It extends the distance between your computer and the device, and it's not as thick... If you're tech savvy, you could make that cable yourself... Nah... You would have done it already  That's what I do... I make stuff I don't want to buy (or better said, I'm to lazy to go out and look for), so my room is filled with custom made wires, cables, several converted power supplies, and other electronics... They don't do anything special, I just love solderin and making stuff... I'm going offtopic... Cable is the only solution for you, as it will allow you to connect 3 standard Jacks in there, and there will be no cramping... Plus, you get a few feet in length
Reply
bluedragon
Jul 22 2008, 07:12 PM
he he.. Thanks all of you @ Galahad - I thought of making the cable but I can't find the right connecters in my area, I found the 3.5 mm jack but couldn't find the RCA  . Shopkeeper says , Nobody asks for it anymore so he stopped keeping it . People are too lazy to do that. I have the proper cable for the job but am missing RCA, which I'll probably get by the end of this month. . I am busy with something. Guess I'll have to change the cables. No software solutions for this one 
Reply
bluedragon
Jul 22 2008, 07:13 PM
Topic is resolved. Moderators please close this topic Thank you
Reply
Recent Queries:--
realtek alc1200 winxp drivers - 10.75 hr back. (1)
-
realtek alc1200 xp driver - 11.11 hr back. (1)
-
realtek alc1200 xp drivers - 18.76 hr back. (1)
-
alc1200 xp driver - 28.55 hr back. (1)
-
retask jack registry - 37.83 hr back. (1)
-
how to tell if your sound card isnt working properly - 48.36 hr back. (1)
-
ad2000b or realtek alc1200 comparison - 50.47 hr back. (1)
-
realtec alc1200 linux module - 59.54 hr back. (1)
-
audio driver might not work properly - 61.00 hr back. (1)
-
realtek alc1200 drivers - 63.59 hr back. (1)
-
alc1200 drivers 5.1 - 74.13 hr back. (1)
-
alc1200 linux driver - 76.69 hr back. (1)
-
what to do if sound card is not working properly? - 78.98 hr back. (1)
-
alc1200 drivers - 85.93 hr back. (1)
Similar Topics
Keywords : sound, card, working, properly, jack, retasking, functionality, missing
- Help For My Seagate Sata Hard Drive!
hard drive stops working randomly, please help! (9)
A:/ Drive Not Found
My A:/ drive is not working. (4) Need your HELP! Today I had to reinstall my operating system and low and behold my A:/ drive
is not working. I have replace the drive and still nothing. My Hard drive and CD rom are showing up
when I go into the BIOS, but are also not reading. I downloaded a Fresh copy of Dos 6.22 which is
what I normally deal with on this PC. I even tried replacing the Jumper Cables from the mother
board to the A Drive, and still Nothing. This is really bugging me. The PC is a Home Brew by the
way.....
Activating Sata Drive With Windows
bought new drive can't get it working (5) I just bought a Samsung SpinPoint 250 GB SATA hard drive last night from Micro Center. The windows
installation disk will not detect it. I have a Abit VT-7 mobo, which does support SATA. I used the
included driver floppy to boot with the installation disk, but it refuses to recgonize it. I'm
going to try to flash the BIOS, but I wanted to know if ya'll had any other ideas. Topic title
is very important. Try naming it with more effort. ....
Harddisk Problem
i got 2 and 1 isn't working (12) here is the problem: i got 2 harddisks. 1 is olmost full, so i wanted to copie somethings in my
second harddisk (wich i never used before) But when i cross the (About) 6 gigabyte... the disk says
that its full... but it can hold 93 gig. And i checked the particle thingy... and cleaned the
disk... nothing works... help me!!!....
Missing Cd Rom From My Computer
when you can't even start the CD-Rom (3) I was called in about 3AM the other day regarding missing CD-ROM drive. You got to be
kidding...right? Well here is what happened. Apparently a computer in the office cannot "find"
CD-ROM or access it. Going into the device manager reveals CODE 19 (registry error) and no one has
any idea what happened. Looking at My Computer shows nothing about CD-ROM drive's icon. Humm
that's funny... So, take a spare CD-ROM drive and just switch it over, right? No! Windows
recognizes that a new hardware is found but the same error message of CODE 19. I'm not about to
s....
Computer Not Working
(9) (Sorry if I posted in the wrong place but I wasn't sure where to put this, move the topic if in
wrong place, thanks). I have this random problem with my pc, and it randomly happened. I turned off
my computer normally at night and came back the next day. I tried turning on the computer and it
came up with something saying like windows could not open and came up with choices. Either I start
the comp in safe mode, safe mode with prompt, with the setting that last worked best, or just start
normally. None of them work! It comes up with the loading xp thing, (the log....
My Drawing Tablet Problem
It is not working! (6) Well, as you can see from the title I have a very big problem which is really bugging me. I
currently possess the trust 400 v2 wireless tablet; before when i bought it it worked fully after
installing al the software which i was meant to - the drivers etc and all fllowing the instruction
manual. That was a while back, then i reformatted my pc and the tablet was left unused for a while
and the battery was taken out. Now, some months later i insert a new battery and install the whole
thing again according to the manual - it worked seamlessly for some hours, pressure and....
Missing Ltp1 Port Can't Install Printer
Missing LTP1 Port Can't Install Printer (8) I have problem installing my printer, the LPT1 Port is missing before it is visible but for unknown
reason it disappeared. Please I Need Help on how to reinstall my LTP1 Port on my computer.....
Sata Hard Drive Not Recognized By Windows
WD 250gb SATA hard drive not working (12) Hi there! I recently re-installed windows on my 250 gb WD SATA hard drive. I had a 50 gb
windows partition and the rest for files. First thing that happened was my system partition
wouldn't boot and eventually chkdsk said that the mbr was unrecoverable. A friend recommended
that i use a seperate parallel hard drive to load windows and then convert the disk to dynamic in
disk management. I did this, but the computer crashed and now windows won't even load with the
SATA hard drive connected. The BIOS sees the SATA hdd, but that's as far as I can get. I tri....
Looking for sound, card, working, properly, jack, retasking, functionality, missing
|
*RANDOM STUFF*
*SIMILAR VIDEOS*
Searching Video's for sound, card, working, properly, jack, retasking, functionality, missing
*MORE FROM TRAP17.COM*
|
advertisement
|
|
