2. make the background color(with paint bucket)#3a3102
3 now get the dodge tool( it will be shown on the printscreen if u don't know where u find the dodge tool)
.........................setting=129 softround brush
..........................range=highlight
.....................exposure=260%
move it like this
make sure u dodge it a lil more in the middle
result=
4.now where gonna use this background below i got from deviantart, i dun realy know the name anymore of the person who made it but anyway
,than drag it into ur background(i used the right side of it),than change the layer style to color dodge
result=
5.oke basicly at state in the signature i don' t want anything to bright.so i'm gonna use the eraser tool with a low opacity to change the brightness a bit,whats the printscreen
after u done that it should look like this
6.now i'm gonna use the wallpaper below,and resize it cause it to big
to resize= image>size canvas>than change the width to 522,the height adjust automaticly
7.so after u resized it drag it into thebackground of the signature,and change the layer style 2 linear dodge
again change the brighter bits a lil,after that flatten the layer
result =
8.now duplicate the layer
layer>duplicate layer>
than change the layer style to overlay
result=
next part is the render a few tips about render placement/size
-make sure the render isn't to big
-look for a render that first the background not only colorwise but alsothe renders movements
-or if the render colors dun match but the render does, than just make sure the render merges in
9. i don't have many renders but i thought the spiderman render would fit
10. again resize it too round about 400width
than drag it in to ur back ground , and get the green stuf deleted so u only have the render itself
result=
11. now get the eraser tool same size as u left it, and erase some of the left arm like i did on the signature below
result=
12.now flatten the layer and use the dodgetool and burn tool to darken and brighten some stuff,
(dodge tool) brightens
(burn tool) darkens
here is my result make it simular, or just skip this,if u lik eit allready
result=
13.at this point u will see that the right site of the signature doesn' t look good,so we will get the selection tool and make a selection like this
14.now while the selection is open push this
ctrl C
ctrl D
ctrl V
u just copied the selection part and,pasted it in the middle. u should have this
15. now drag that piece of copied sign to the right ,simular to mine below
16, now get a very small grungie brush to erase some of the part u just copied, so ur right part of the sign dun look like a straight line anymore,,,
my result=
17. now flatten the layer,than duplicate the layer.
than go to layer>adjustment layer>black%white
with these settings
18, now the duplicate layer, should look black,stay on this layer and change th elayer style 2 pinlight
this i sthe end result
